UTX USA Version 1.3 Patch Instructions

Overview

Upgrading
your version of UTX USA
from version 1.2 to version 1.3 is a simple 3 step process:

Download the compressed patch
contents (UtxUsaV13.zip).

Unzip the patch contents (2
files) to the folder location of your choice.

Run the patch preparation application
that were downloaded and start the patch process.

A patch preparation step has been provided that will ensure that
your UTX USA
environment is configured properly and ready to receive the patch. The actual
patch installer will only be unlocked after the patch preparation step has been
successfully executed.

Step 1:
Downloading The Patch

Click
on the link below and save the patch to your hard disk (any location). The
patch is roughly 200mb in size.

Download
UtxUsaV13.zip

Step 2:
Extract The Downloaded File Contents To Your Hard
Drive

The
patch files are stored in a compressed Zip file format. There are two files
that should be extracted to your hard drive from the file that is downloaded.

FSXPATCH.EXE – Patch
preparation application

UtxUsaV13.EXE – Actual
UTX USA Version 1.3 patch (currently locked)

Please
do not execute the UTXUSAV13.EXE patch application directly after download. If you
try to run the application, it will fail. This was done for security measures.

Step 3: Begin
The Patch Preparation Process

From
the location that you extracted the compressed files to, execute the
UTXPATCH.EXE application. First, the application will try and locate the FSX
install location by reading the windows registry. If successful, you will see a
window similar to below and the “Patch Preparation” button will be
enabled (clickable).

If FSX cannot be located using the windows registry entry for FSX,
then you will need to locate it yourself using the “Change FSX
Location” button.   After
pressing the “Change FSX Location” button, you will need to browse
to the FSX install folder (the folder containing FSX.EXE).  The “Patch Preparation”
button will only be enabled if FSX has been successfully found with a valid UTX
USA
installation.

Click the
“Patch Preparation” button to start the patch preparation
process.  This is not the actual process that will
upgrade you to version 1.3.
Instead, this button starts the process that gets your environment ready
for the patch.

You will be
notified when the patch preparation process is complete (quick process). If
successful, the “Launch Patch Application” button will become
active.  This indicates that the
actual patch application (UtxUsaV13.exe
) has been unlocked and is ready
to use.   You can start the
actual patch process now by pressing the “Launch Patch Application”
button.  Or you can run the process
later on by executing the UtxUsaV13.exe application directly from your hard
drive.

When you
start the patch application, you will see the window below:

Follow the
patch instructions to install the patch. Your version of UTX USA will not be
upgraded until the patch application has completed. After the patch process is
complete, your version of UTX USA
will be upgraded to Version 1.3.    You can always find out the
version of UTX USA
that is currently installed, by running the UTX setup tool that was installed
when you purchased the software.

If you need
assistance with the patch process, please visit our support forum at:

http://www.simforums.com/forums/forum_topics.asp?FID=19

Removing The Patch Files

After you
successfully install the UTX USA patch, you can remove the following files from
your hard drive if desired, because they are no longer needed.

•
FSXPATCH.EXE

•
UTXUSAV13.EXE

•
UtxUsaV13.zip